Fcc Information - Kustom Signals ProLaser III Operator's Manual

ProLaser III Operator's Manual

FCC INFORMATION

Since the ProLaser III is not designed to transmit RF
(radio frequency) radiation, an FCC station license is not
required for operation of the device. However, the
ProLaser III does employ internal high frequency digital
circuitry to perform its functions, and therefore is
classified as a Class A digital device in accordance with
Part 15 of FCC Rules and Regulations.
The ProLaser III has been tested and found to comply
with the limits for a Class A digital device pursuant to Part
15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
commercial installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Page 38