JVC GET0624-003A Instructions Manual page 23

Symptom
Noise is generated.
"READING" keeps flashing on
the display.
"NO FILE" appears on the
display.
"NOT SUPPORT" appears on the
display and track skips.
Tracks/folders are not played
back in the order you have
intended.
• "CANNOT PLAY" flashes on
the display.
• "NO USB" appears on the
display.
• The unit cannot detect the
USB device.
The correct characters are not
displayed (e.g. album name).
While playing a track, sound is
sometimes interrupted.
JVC bears no responsibility for any loss of the data in the USB mass storage class device
while using this System.
Remedy/Cause
The track played back is not an MP3/WMA track. Skip to
another file. (Do not add the extension code <.mp3> or
<.wma> to non-MP3 or WMA tracks.)
• Readout time varies depending on the USB device.
• Do not use too many hierarchy or folders.
• Turn off the power then on again.
• Reattach the USB device again.
Selected folder is an empty folder*. Select another
folder that contains MP3/WMA tracks.
* Folder that is physically empty or folder that contains
data but does not contain valid MP3/WMA track.
Skip to the next track encoded in an appropriate format
or to the next non-copy-protected WMA track.
The playback order is determined by the write-in time
stamp. The first track/folder written into the USB device
will be the first track/folder for playback.
• Attach a USB device that contains tracks encoded in
an appropriate format.
• Reattach the USB device again.
This unit can only display letters (upper case), numbers,
and a limited number of symbols.
The MP3/WMA tracks have not been properly copied
into the USB device.
Copy MP3/WMA tracks again into the USB device, and
try again.
ENGLISH 23