Table of Contents
Advertisement
MK-1080 PAVER SAW
NOTICE
•
Before using the machine, check for any broken, worn or damaged parts and replace them immediately.
•
ALWAYS keep the machine clean and lubricated.
•
ALWAYS unwind the power supply cord completely and check for damage.
•
Carefully check the "Technical Data" Label before plugging in the machine. Follow the extension cord
requirements, as recommended on the machine label.
•
Work on a level and clean surface.
SAW FRAME
1.
The Conveyor Cart is secured for shipping by plastic ties. Remove these plastic ties before use.
2.
Ensure that the Cart runs smoothly along the tracks of the Inner Frame.
INSTALLING THE BLADE
1.
While holding the cutting head handle down to counteract spring tension, loosen the cutting head lock screw
and allow the cutting head to gently rise to its highest point. (Figure 7).
2.
Slide the cutting table to the front of the saw and raise the blade guard (Figure 8). It may be necessary to ad-
just the tightness of the blade guard wing nut (Figure 9). When properly tightened, the blade guard will move
relatively easily and also stay in the raised position.
3.
Locate the shaft lock push button on the underside of the cutting head (Figure 10).
4.
Depress the shaft lock push button and rotate the arbor shaft till the button locks the arbor shaft in position.
If necessary, use the blade wrench to turn the retaining nut counterclockwise to loosen from the arbor shaft
(Figure 11). Remove the nut and slide the outer flange (Figure 15) from the arbor shaft (Figure 12).
Fig. 7 Loosen Cutting Head Screw
Fig. 10 Locate Shaft Lock Button
Fig. 8 Slide Table and Raise Blade
Fig. 11 Rotate Arbor Shaft
16
INSPECTION & SET-UP
Fig. 9 Adjust Blade Guard Tightness
Fig. 12 Remove Nut and Outer Flange
Advertisement
Table of Contents
