Table of Contents
Advertisement
MK-1080 PAVER SAW
OPERATION & SAFETY DECALS
The MK-1080 Paver Saw is equipped with a number of safety decals. These decals are provided for opera-
tor safety and maintenance information. The photo on the next page also shows the location of these decals.
Should any of these operation or safety decals become unreadable, replacements can be obtained by calling
(800) 262-1575.
Decal A
NOTICE
!
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
115v 230v
Max. Cord Length
25'
100'
50'
150'
Max. Cord Length
75'
250'
Max. Cord Length
Decal C
CAUTION
!
Receptacle is for
water pump only.
125V .6 amps max.
Decal G
WARNING
!
DO NOT operate
this equipment
before reading
the owners'
manual!
No. 12 Wire
No. 10 Wire
No. 8 Wire
Figure 5. MK-1080 Paver Saw Safety Decal Sheet, Part No. 166011
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
CAUTION
!
This saw is to be used
with a Ground Fault
Circuit Interrupter.
Decal D
CAUTION
!
DO NOT
operate without
guards in place.
Decal E
!
CAUTION
DO NOT
operate without
guards in place.
Decal H
12
WARNING
!
Decal B
FOR INFORMATION ON
SERVICE OR
WARRANTY
PLEASE CALL
1-800-474-5594
Decal F
!
In the event of
blade failure,
replace blade
guard
immediately.
Decal I
SAFETY
WARNING
Advertisement
Table of Contents
