Table of Contents
Advertisement
Fig. 1
Charging Procedure (Fig. 1)
1. Insert the charger cable into charging inlet (19) on the tool.
2. Making sure the wall outlet in your home is normal household voltage (AC230-240V,
50Hz); insert the battery charger plug into the mains power supply.
3. The red LED charging indicator (20) lights up to tell you that the battery pack is on
charge. The battery is fully charged when the red LED charging indicator (20) is no
longer lit.
During the charging process, the handle of the tool will warm up, but this is
perfectly normal.
When not using the tool for extended periods, disconnect the battery charger from
the socket.
When the trimming shears are charging, you must not use them.
Only charge the battery between 10º- 45ºC
After prolonged use, allow battery to cool down first before recharging.
1. Starting and Stopping for cutting without telescopic handle (Fig.12)
Starting:
1) Push in the safety lock (2) and press the On/Off trigger (5) at the same time.
2) Release safety lock (2).
Stopping:
Release the On/Off switch (5).
Fig. 12
20
19
Assembly
Starting and Stopping
5
2
8
Advertisement
Table of Contents
