Table of Contents
Advertisement
Fitting (Fig. 18-24)
Fit the blade, there are two holes on the blade and two driving pins on the body. First
align the end of blade inside the plastic housing, align the rear hole in the blade onto
the rear drive pin (23). (Fig.18 and Fig.19).
Moving the raised rib (22) left and right for grass shear blade (Fig.20),Moving the
raised rib (22) up and down (Fig.21) for shrub trimming blade to let the front drive pin
(24) enter the front hole in the blade (Fig.22 and Fig.23).
When refitting the SDS blade cover, ensure all 4 legs are inside the housing before
sliding the cover into place.
Replace the blade cover, by sliding it back towards the blade (Fig.24).
Fig.18
24
Fig.20
Fig.22
22
23
12
22
Fig.19
24
Fig.21
Fig.23
23
Advertisement
Table of Contents
