Table of Contents
Advertisement
Fig.9
Adjusting the length of telescopic handle (Fig.9-10)
1) Loosen the adjusting bolt (15) (Fig.9)
2) Pull the tube out to increase the height, or push the tube in to decrease the height.
(Fig.10)
3) Re-tighten the adjusting bolt (15). (Fig.9)
Fig.11
Adjusting for edging mode (Fig.11)
1) Mount the telescopic handle in 90º or -90º direction into the wheel holder to position the
machine in the vertical edging mode. (Fig.11)
2) Plug in the handle connector (9)
Fig.10
17
Advertisement
Table of Contents
