Table of Contents
Advertisement
UPGRADING USB BRIDGE FIRMWARE
1) Connect the USB cable between the scanner and your computer.
If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM.
2) Read the following barcodes in sequence to configure the scanner to use USB Virtual
COM as download interface.
3) Read the following barcodes in sequence for the scanner to enter the download mode.
The scanner will respond with beeps to indicate it is ready for downloading.
4) Run the download utility "ProgLoad.exe" on your computer.
Kernel Program
K170xBridge_V*.shx
Enter Setup
Enter Setup
Download USB Bridge
Firmware
Appendix I
Activate USB
Virtual COM
Update
User Program
STD170xBridge_V*.shx
Update
Firmware Upgrade
201
Advertisement
Table of Contents
