Operation Modes; Dmx Function Chart - Equinox Systems VIXEN EQLA36 User Manual

Equinox Vixen Laser

Operation modes

Operation modes:
The Vixen has five modes of operation as follows:
1, Sound active mode
To select sound active mode set all dip switches to OFF. You can now use the sensitivity control on
the back panel to set the required sound level.
2, Auto pattern mode
To select auto pattern mode, set dip switch 1 to the ON position and all others to OFF. The
Vixen will now cycle through all it's internal geometric patterns.
3, Auto animation mode
To select auto animation pattern mode, set dip switches 1 + 2 to the ON position and all others to
OFF. The Vixen will now cycle through all it's internal animation programmes such as a
numbers, running dinosaur and flying bird etc.
4, DMX mode
To select DMX mode, set dip switch 10 to ON. You can now set the required DMX address using
dip switches 1 to 9. Please refer to the chart below for DMX functions. The DMX address starts at 1.
5, Slave mode
To set the unit/s in slave mode, set dip switch 2 to the ON position and all others to OFF. The
Vixen laser will now run in sequence with the master unit.

DMX function chart: