Rebooting The System; Automatic Configuration - Sun Microsystems SunSAI/P User Manual

Rebooting the System

If you have installed additional boards since you have installed the driver software,
perform a reconfiguration boot before using the saipconfig utility.
1. Shut down your system and display the OpenBoot prompt (ok) using the
procedures described in the Solaris Handbook for Sun Peripherals or your system
service manual.
For example, you can shut down the system using the shutdown command:
# /usr/sbin/shutdown -y -g10 -i0
Refer to the shutdown(1m) man page for more information.
2. Perform a reconfiguration book by typing the following at the OpenBoot prompt:
ok boot -r

Automatic Configuration

Follow this procedure to use the saipconfig utility to configure the SunSAI/P
interfaces on your system automatically.
1. Log onto to your system console as superuser (root).
2. To start the saipconfig utility, type:
# /etc/opt/SUNWconn/bin/saipconfig
3. Answer yes (y) to accept the default configuration.
The installation has detected 1 SunSAI/P serial adapter.
Would you like to automatically install the default configuration? y
Chapter 5 Device Driver Installation 19