Dodge 1500 User Manual page 53

• Simultaneously, press and hold both the chosen HomeLink
hand-held transmitter button until the HomeLink
from a slow to a rapidly blinking light, then release both the HomeLink
the hand-held transmitter buttons. This may take up to 30 seconds, or longer
in rare cases.
• Press and hold the just-programmed HomeLink
stays on constantly, programming is complete and the garage door should
open.
NOTE:
• Only use this transceiver with a garage door opener that has a "stop and
reverse" feature as required by Federal safety standards. This includes most
garage door opener models manufactured after 1982. Do not use a garage door
opener without these safety features. Call toll-free 1–800–355–3515 or, on the
Internet, at www.HomeLink.com for safety information or assistance.
• If you are having difficulty programming your HomeLink
opener was manufactured after 1995, you may have a rolling code. Follow the
steps below for Programming A Rolling Code System.
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or
"programming" button. This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is NOT the button
normally used to open and close the door).
• Firmly press and release the "learn" or "programming" button. The name and
color of the button may vary by manufacturer. Within 30 seconds, return to the
vehicle and press the programmed HomeLink
button for two seconds each time). If the device is plugged in and activates,
programming is complete.
• If the device does not activate, press the button a third time (for two seconds)
to complete the programming.
Using HomeLink
®
• To operate, simply press and release the programmed HomeLink
the programmed device will operate.
• Refer to your Owner's Manual on the DVD for further details. If you have any
problems programming HomeLink
1–800–355–3515 or, on the Internet, at www.HomeLink.com.
• Your motorized door or gate will open and close while you are programming
the universal transceiver. Do not program the transceiver if people or pets are
in the path of the door or gate.
®
® button twice (holding the
® , or require assistance, please call toll-free
WARNING!
ELECTRONICS
® button and the
® indicator flash rate changes
button; if the indicator light
® and your garage door
® button and
® and
(Continued)
51