Table of Contents
Advertisement
Other convenient tuner functions
Control dial
Scanning broadcast stations
When you press SCAN while listening to the radio, station scanning starts. Each time a
broadcast is tuned in, scanning stops for about 5 seconds (SCAN flashes on the display), and
you can check what program is now being broadcasted.
If you want to listen to that program, press the same button again to stop scanning.
Selecting FM reception sound
When an FM stereo broadcast is hard to receive:
Press
MO RND (Dolby NR/Monaural/Random) while listening to an FM stereo broadcast.
The MONO indicator lights up on the display. The sound you hear becomes monaural but
reception will be improved.
Lights up when receiving an FM broadcast in stereo.
To restore the stereo effect, press the same button again.
Changing the AM/FM channel intervals
When using this unit in an area other than North or South America:
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM. You can change the channel intervals by following the procedure below.
• See also "Changing the general settings (PSM)" on page 20.
1. Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select "AREA" with
3. Rotate the control dial clockwise.
"AREA EU" appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above step 1 and 2, then rotate the control dial
counterclockwise in step 3 ("AREA US" appears on the display).
AREA EU: Select this when used in an area other than North and South America.
AREA US: Select this when used in North or South America.
SEL
SCAN
¢ or
4.
¢
4
MO RND
9
Advertisement
Table of Contents
