Table of Contents
Advertisement
Available languages
Available languages
Changing the input signal
The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote
Control or TV/VIDEO on the unit.
Remote Control
The input mode changes each time this
button is pressed.
*
Card input mode (Photo Viewer) is
selected.
Projection Display Unit
*
*
Video 1
Signal of source connected to INPUT 1 is displayed.
Video 2
Signal of source connected to INPUT 2 is displayed.
Video 3
Signal of source connected to INPUT 3 is displayed.
Comp 1
Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.
Comp 2
Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.
Comp 3
Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.
RGB 1
Signal of source connected to RGB IN 1 is displayed.
RGB 2
Signal of source connected to RGB IN 2 is displayed.
HDMI
Signal of source connected to HDMI IN is displayed.
Photo (Photo Viewer)
Signal of source connected to CARD SLOT is displayed.
1
If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 71.)
Or
1
Changing input is only possible if Cable/
Antenna is set as the Input Set setting.
2
If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 71.)
Projection display operation
TV
Video 1*
1
Video 2*
1
Video 3*
1
TV (Antenna A)
TV (Antenna B*
)
1
Video 1*
2
Video 2*
2
Video 3*
2
HDMI*
1
RGB 2*
1
RGB 1*
1
Comp 3*
1
Comp 2*
1
Comp 1*
1
HDMI*
2
RGB 2*
2
RGB 1*
2
Comp 3*
2
Comp 2*
2
Comp 1*
2
37
Advertisement
Chapters
Table of Contents
