Vermont Castings DVR28IN Homeowner's Installation And Operating Instructions Manual page 4

Vermont Castings DVR28 Direct Vent Gas Fireplace
Installation & Operating Instructions
�������
�
BREAKING IN YOUR NEW FIREPLACE
•
Remove any plastic covering materials that
may still be adhering to the trim parts, before
turning the fireplace ON for the first time.
•
Burn the fireplace for at least ten (10) hours
the first time you use it, to break it in properly. If the
optional fan kit has been installed, place the fan
switch in the "OFF" position during this time.
•
It is normal for fireplaces fabricated of steel to give
off some expansion and/or contraction noises during
the start up and cool down cycles. Similar noises are
produced by your furnace heat exchanger and your
car engine.
•
It is also not unusual for your gas fireplace to give off
some odor the first time it is burned. This is due to the
curing of the paint and any undetected oil from the
manufacturing process.
•
Provide adequate ventilation during the breaking in
process by opening all windows.
4
��� ����� ����
����� ������
�� ��� ����� �����
����� �������
����� ����� ��������
�� ����� ������
Proposition 65 Warning:
Fuels used in gas, wood burning or oil fired
appliances, and the products of combustion
of such fuels, contain chemicals known to
the State of California to cause cancer, birth
defects and other reproductive harm.
California Health & Safety Code Sec. 25249.6
CAUTION
Check with your electronics manufacturer before
installing a television set or other electronic device
above this fireplace.
NOTICE
DVR28IN Certified to ANSI Z21.88b-2008 / CSA 2.33b-
2008 Vented Gas Fireplace Heaters
This Direct Vent Gas Fireplace utilizes a sealed
combustion system in which outside air is brought
into the fireplace and the products of combustion
are exhausted from the fireplace through two sepa-
rate concentric passageways within the same metal
vent pipe. Since the vent pipe extends vertically
through an exterior wall or through the roof to the
atmosphere, the fireplace does not use room air for
combustion.
20012301