Remote Control Transmitter Operating Instruction - Vermont Castings DVR28IN Homeowner's Installation And Operating Instructions Manual

Vermont Castings DVR28 Direct Vent Gas Fireplace
If you cannot read or understand these installation instructions, do not attempt to operate.
Introduction
This transmitter operating range is approximately 20 feet (6 m). The transmitter operates on one of 1,048,576 security
codes that are programmed into the transmitter at the factory; this transmitter operates on radio frequencies with non-
directional signals. The receiver for this transmitter is built into the AF-4000 MOD module.
Transmitter
��
On H/L
Button
Off
ON H/L
Continuous
OFF/CONTINUOUS
Pilot Button PILOT BUTTON
MODE
Mode Button
SET
Set Button
ON H/L
FP1818
Skytech remote
9/07
OFF
Continuous
Pilot
MODE
SET
LCD - Liquid Crystal Display
�����
7
1
����
4
22
Hand-Held Remote Transmitter Operating Instructions
Wall Clip
Slot
Battery
Compartment
FP1818
1
2
3
4
���
����
6
FP1819
LCD display
9/07
The transmitter operates on (2) 1.5V AAA batteries. It is recom-
mended that ALKALINE batteries always be used for longer
battery life and maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter bat-
teries into the battery compartment. (Use caution that batteries
are installed in the proper direction.)
Key Settings
1. ON H/L
2. OFF
CONTINUOUS PILOT
3. MODE
4. SET
1. DISPLAY Indicates CURRENT room temperature.
2. ° F or ° C Indicates degrees Fahrenheit or Celsius
2
3. FLAME Indicates burner/valve in operation
4. ROOM Indicates remote is in THERMO operation
5. TEMP Appears during manual operation
3
6. SET Appears while setting the desired tem-
perature in the thermo operation
7. PILOT Appears in the Continuous Pilot mode
5
— Turns unit to ON and operates
the flame control HI or LO.
— Shuts the unit OFF and acti-
vates the continuous pilot on
feature.
— Changes unit from manual
mode to thermo mode.
— Sets temperature in thermo
mode.
20012301