Table of Contents
Advertisement
Rear Panel of EPN-102
Rear Panel Port and Button Definition
Connector
ON / OFF
The power button is for turn on or turn off the ONU.
The reset button can restore the default settings of device. To restore factory
RESET
defaults, keep the device powered on and push a paper clip into the hole. Press
down the button over 5 seconds and then release.
PWR
Power connector with 12V DC 1A
ONU is successfully connected to a device through the 10/100 Fast Ethernet port.
10/100
If the FE LED is flashing, the ONU is actively sending or receiving data over that
port.
ONU is successfully connected to a device through the 10/100/1000 Gigabit
10/100/1000
Ethernet port. If the GE LED is flashing, the ONU is actively sending or receiving
data over that port.
The PON connector allows data communication between the ONU and the OLT
PON
through a single mode fiber.
Description
8
Advertisement
Table of Contents
