Table of Contents
Advertisement
Rear Panel of EPN-104
Rear Panel Port and Button Definition
Connector Description
ON / OFF
The power button is for turn on or turn off the ONU.
The reset button can restore the default settings of device. To restore factory
RESET
defaults, keep the device powered on and push a paper clip into the hole. Press
down the button over 5 seconds and then release.
Power connector with 12V DC 1A
PWR
ONU is successfully connected to a device through the corresponding port (1, 2, 3,
Ethernet
or 4). If the LED is flashing, the ONU is actively sending or receiving data over that
1-4
port.
The PON connector allows data communication between the ONU and the OLT
PON
through a single mode fiber.
10
Advertisement
Table of Contents
