JVC GET0602-001A Instruction Manual page 146

D
Connecting the external components
AV amplifier or decoder
External component
Only for KW-AVX726/KW-AVX724
Connecting the USB devices
USB cable (approx. 1.2 m)
You cannot connect a computer to the USB (
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
iPhone is a trademark of Apple Inc.
E
Connecting the external components to the CD changer jack
When connecting the external components, refer also to the manuals supplied for the components and
adapter.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component
CD changer (CD-CH)
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component
Bluetooth device
iPod
Portable audio player with line output jacks
Portable audio player with 3.5 mm stereo mini jack
* 3
Not supplied for this unit.
*
4 When using the cable, make sure <iPod (Off)> is selected for <AV Input> (see page 15 of the INSTRUCTIONS).
* 5 To use these components, set the external input setting correctly (see page 16 of the INSTRUCTIONS).
* 3
Digital optical cable
* 3
Signal cord
Connecting the iPod/iPhone to the USB terminal
You can connect the iPod/iPhone to the USB terminal using the following cables:
• To listen to the music: USB 2.0 cable (supplied with the iPod/iPhone)
• To watch the video: USB Audio and Video cable for iPod/iPhone—KS-U30 (not supplied) *
USB device
) terminal of the unit.
Model name
CH-X1500, etc.
Adapter Model name
Bluetooth adapter KS-BTA200
Interface adapter for iPod KS-PD100
Line input adapter KS-U57
AUX input adapter KS-U58
*
Video cord 3
USB 2.0 cable
KS-U30
When connecting more than one component (maximum: two), it is recommended that you connect the
components in series as explained below.
When connecting two components in series
CD changer jack
A KS-BTA200
B * 5 CD-CH / KS-PD100 / KS-U57 / KS-U58
To disconnect the connector
Hold the connector top tightly (
4
* 3
Video cord
External monitor
KV-CM1 *
3
Rear view camera
4
Apple iPod/iPhone
Apple iPod/iPhone
1 ), then pull it out (
*
5
2 ).