Setting Up The Gprs Communication; Establishing Gprs Connection; Restoring The Gprs Connection - ABB RER601 Technical Manual

Wireless gateway
Hide thumbs Also See for RER601:
Table of Contents

Advertisement

Section 6
Troubleshooting
6.5
6.6
6.7
62

Setting up the GPRS communication

The GPRS interface may be set up but there is no communication.
Set the default gateway in the Ethernet settings submenu to "0".
Enable the default gateway from Network/GPRS if the GPRS interface is
used as a default gateway.

Establishing GPRS connection

The GPRS connection may not be established.
Check that the SIM card has the correct PIN number settings and that it has not
been locked due to entering the wrong number three times successively.
Check the PIN status from Tools/Modem Info.

Restoring the GPRS connection

The GPRS connection fails approximately after two minutes if the connection
checking has been enabled in Network/Monitor but the correct IP has not been set
to GPRS in ICMP Echo settings.
Set the correct IP to GPRS in Network/GPRS/ICMP Echo.
1MRS757105 B
RER601/603
Technical Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rer603

Table of Contents