Connecting Cable Assemblies; Figure 1-1. Readyboard 800 Connector Locations - Ampro ReadyBoard 800 Quick Start Manual

Single board computer
Hide thumbs Also See for ReadyBoard 800:
Table of Contents

Advertisement

Chapter 1

Connecting Cable Assemblies

Connect the cables provided with the ReadyBoard 800 QuickStart Kit to the respective connectors on the
ReadyBoard 800. Skip any steps or cable(s) that do not apply to your situation.
ATX Power-On (J1)
ATX Power In (J2)
Fan (J7)
GPIO (J8)
Serial 3 & 4 (J11A/B)
(COM 3 & 4)
1) Connect the Floppy only
Cable
2) If you want Printer only
perform this step
3) Connect the Primary
IDE cable
4) Connect the Keyboard/
Mouse Y-cable
ReadyBoard 800
SMBus (J25)
Infrared (J9)
PCI-104 (J3)

Figure 1-1. ReadyBoard 800 Connector Locations

• Connect the Floppy only cable to J10 on the edge of the ReadyBoard 800
as shown in Figure 1-2. Refer also to Figures 1-1, 1-4.
The Floppy interface and Parallel Port share interface connector J10. You
must choose which cable to connect to the J10, depending on the desired
function; floppy only cable, or printer only cable.
• If you only want a Printer (parallel) and don't need a floppy drive, then
remove the Floppy only cable and connect the Parallel (printer) only
cable to J10 on the edge of the ReadyBoard 800 as shown in Figure 1-3.
Refer also to Figures 1-1, 1-4.
• Connect the Primary IDE cable to J6 on the edge of the ReadyBoard 800
as shown in Figure 1-3. Refer also to Figures 1-1, 1-4.
This cable provides two IDE connectors (40-pin) for an IDE device,
such as an IDE hard disk drive (HDD) or IDE CD-ROM, etc.
A 44-pin-to-40-pin cable is provided for a 3 ½" IDE device, and
NOTE
a 44-pin-to-44-pin cable is provided for a 2 ½" IDE HDD.
• Connect the Keyboard/Mouse Y-cable assembly to the Keyboard/Mouse
port (J19) on the edge of the ReadyBoard 800 as shown in Figure 1-3.
Refer also to Figures 1-1, 1-4.
This cable assembly provides two connectors for the PS/2 Keyboard-
PS/2 Mouse shared port and each PS/2 connector has an icon for the
respective PS/2 device.
QuickStart Guide
Setting Up the ReadyBoard 800
Primary IDE (J6)
Floppy/Parallel (J10)
Audio In/Out (J4)
(hidden)
Ethernet 2 (J17)
Ethernet 1 (J16)
CRT (J21)
Serial 1 & Serial 2 (COM 1 & 2)
(J15A/B) (Serial 1 Lower)
Utility (J12)
(hidden)
PS/2 Keyboard/
Mouse (J19)
USB 0 & 1 (J18)
(USB 0 Lower)
3

Advertisement

Table of Contents
loading

Table of Contents