Honda Vehicle Owner's Manual page 267

06/10/30 17:18:11 32SJD620_267
Lights
2. Determine which of the four bulbs
is burned out: stop/tail-light, back-
up light, turn signal light or rear
fog light.
3. Remove the socket by turning it
one-quarter turn anticlockwise.
264
Maintenance
4. Pull the bulb straight out of its
socket.
5. Install the new bulb in the socket.
Test the lights to make sure the
6.
new bulb is working.
Reinstall the socket by turning it
clockwise until it locks.
7. Reinstall the cover.
Connect the band connector.
Replacing a High-mount Brake
Light Bulb
HIGH-MOUNT BRAKE
LIGHT ASSEMBLY
SCREW
SCREW COVERS
1. Place a cloth on the edge of the
cover. Remove the covers by
carefully prying on the edge with a
small flat-tipped screwdriver.
Use a Phillips-head screwdriver to
remove the two screws, then
remove the high-mount brake
light assembly.