Advertisement
MAC501
WARNING:
ELECTRICAL SHOCK HAZARD!
OR DRILLING INTO ELECTRICAL WIRES OR
CABLES CAN CAUSE DEATH OR SERIOUS
PERSONAL INJURY!
ALWAYS make certain area behind
mounting surfaces is free of electrical wires and cables
before cutting, drilling, or installing fasteners.
6.
Drill six 3/16" diameter pilot holes in studs at mounting
holes.
7.
Attach the MAC-501 (A) using six M7 x 40mm Allen head
connector screws (B) into pilot holes using an M4 Allen
head drill bit (D).
DANGER:
IMPROPER WIRING CAN LEAD TO DEATH
OR SEVERE PERSONAL INJURY! Grounding must be
installed by qualified personnel using a UL Recognized No.
12AWG Green and Yellow grounding wire connected to
grounding lug on mount.
Grounding Lug Locations
Figure 3
Installing Arm Kit
Install arm kit following instructions included with the kit.
6
CUTTING
Installation Instructions
Advertisement
