Outlook Main Harness - Bully Dog Power Pup Installation Manual

INSTALLATION STEPS
INSTALLING.ThE.OUTLOOK.MAIN.hARNESS
IMPORTANT: This step is performed on all vehicles.
In this step you will run the OutLook Main harness,
page 2 #3, behind the weather stripping and connect
the OutLook Main harness to the OBDII Harness, page
2 #7.
1. For a clean install, first peel-back the weather stripping next
to the dash on the driver' s side door.
Dodge Install
Harness Connections
9

OutLook Main Harness (#1)

2. Set the OutLook Monitor up on the driver' s side dash
and run the OutLook wires down behind the dash to
conceal the wiring. Remove the side dash panel to assist
in running the wiring. Reinstall the side dash panel and
the weather stripping.
3. On the inside of the cab, connect the green plug with
the female pins and male shell on the end of the OBDII
Harness to the green plug male pins and female shell
on the OutLook Main harness.
4. Go inside the cab of the vehicle to test the install
before going any further. Turn the ignition to the run
position: at this point the OutLook should light up and
display a vehicle selection screen. If the screen does not
light up, please refer to the Trouble Shooting section on
page 21.
5. Secure all wiring to ensure that it is safe from
extreme heat and moving parts using zip ties provided.
Be sure save some zip ties for the Pyrometer Probe or
Probes.