Lake LM Series Operation Manual page 49

7.1.2 Analog Input XLR Connections
Two (LM 26) or four (LM 44) electronically-balanced analog inputs are provided via latching XLR3F connec-
tions.
OUTPUT 2 OUTPUT 3 OUTPUT
7.1.3 Analog XLR Wiring and Pin Out
All XLR connections are wired to IEC268 as shown in Figure 7-5.
Pin 1: Ground / Shield
Pin 2: Hot (+)
Pin 3: Cold (-)
7.1.4 Unbalanced Operation
Balanced connections are recommended where possible. However, if it is necessary to drive the device
from equipment with an unbalanced output, wire the inputs as shown in Figure 7-6.
4 OUTPUT 5 OUTPUT 6
Figure 7-4: Analog Input XLR Connections (LM 26)
Figure 7-5: IEC268 XLR Wiring and Pin Out
HOT
COLD
SCRN
Unbalanced Output
(Typically phono)
Figure 7-6: Balanced to Unbalanced Analog Wiring and Pin Out
INPUT 1 INPUT 2
Balanced Input
(XLR)
Lake LM Series Operation Manual Rev 1.3.5
Back Panel Interface
AES/EBU
2 1
HOT
COLD
3
SCRN
ACT PRIM LINK ACT SEC LINK
SWITCHED 100/1000 Base-T
43