Lake LM Series Operation Manual page 43

Front Panel Interface
Factory Reset
A Factory Reset will reset all settings and parameters to the original factory-defined default values. This
includes the deletion of any Frame Presets stored within the device, and the relevant Frame configuration
for the device (LM 26 = Contour; LM 44 = Mesa). It also resets the IP Address and all network related
settings including the Dual Redundancy setting; a hard power cycle is required to complete this reset.
Contour Reset
A Contour Reset will configure the Frame in Contour Loudspeaker Processor Mode (2-in, 6-out) and will
reset all settings and parameters to the original factory-defined default values for that configuration. Frame
Preset information and IP / Network configuration will be unaffected. A power cycle is not required to
complete this type of reset.
Mesa Reset
A Mesa Reset will configure the Frame in Mesa System Processor Mode (4-in, 4-out) and will reset all
settings and parameters to the original factory-defined default values for that configuration. Frame Preset
information and IP / Network configuration will be unaffected. A power cycle is not required to complete this
type of reset.
6.10.4.3 Latency Match
To turn Latency Match on or off, select the parameter using the adjacent button then change the status
using the rotary encoder.
When Latency Match is ON the LM Series device adds delay to match the overall processing delay of legacy
Lake Contour Pro 26 and Mesa Quad EQ products. Please refer to the Lake Controller Operation Manual for
further information.
6.10.4.4 GPIO
MENU > FRAME > GPIO
Figure 6-22: GPIO Menu
37
Lake LM Series Operation Manual Rev 1.3.5