Brakes Overheating; Noisy Suspension - VESPA LX 50 Workshop Manual

Troubleshooting

Brakes overheating

Possible Cause
Defective piston sliding
Brake disc or drum deformed
Electrical system
Battery
Possible Cause
Battery
Steering and suspensions
Heavy steering
Possible Cause
Torque not conforming
Excessive steering play
Possible Cause
EXCESSIVE STEERING CLEARANCE

Noisy suspension

Possible Cause
NOISY SUSPENSION
TROUBL - 42
BRAKES OVERHEATING
BATTERY
The battery is the electrical device in the system that requires
the most frequent inspections and thorough maintenance. If the
vehicle is not used for some time (1 month or more) the battery
completely in the course of 5 ÷ 6 months. If the battery is fitted
on a motorcycle, be careful not to invert the connections, keep-
negative terminal while the red wire is connected to the terminal
marked+. Follow the instructions in the ELECTRICAL SYSTEM
STEERING HARDENING
If irregularities continue in turning the steering even after mak-
ing the above adjustments, check the seats in which the ball
EXCESSIVE STEERING CLEARANCE
If irregularities continue in turning the steering even after mak-
ing the above adjustments, check the seats in which the ball
NOISY SUSPENSION
If the front suspension is noisy, check: the efficiency of the front
shock absorbers; the condition of the ball bearings and relevant
Operation
Check calliper and replace any damaged part.
Using a dial gauge, check the planarity of the disk with the
wheel correctly fitted or the concentricity of the rear drum.
Operation
needs to be recharged periodically. The battery runs down
ing in mind that the black ground wire is connected to the
chapter for the recharging of the batteries.
Operation
Check the tightening of the top and bottom ring nuts.
bearings rotate: replace if they are recessed.
Operation
Check the tightening of the top and bottom ring nuts.
bearings rotate: replace if they are recessed.
Operation
Vespa LX 50