Disc Inspection; Front Brake Pads - VESPA LX 50 Workshop Manual

Braking system
tightening torque
5 ÷ 6.5 Nm

Disc Inspection

Specific tooling
020335Y Magnetic support for dial gauge
Characteristic
Max oscillation allowed
0.1 mm.

Front brake pads

Removal
- Pads must be replaced when the friction material
thickness reaches the wear limit.
- To replace:
remove the protection cover, the bolt and the leaf
spring. Slide off the pads and replace them once
the plungers are down. Carry out these operations
in reverse order to fit.
CAUTION
BEFORE USING THE BRAKE, OPERATE THE LEVER A
FEW TIMES.
Front
-Once the bleed valve is closed, fill the system with
brake liquid to the maximum level.
-Undo the bleed screw.
-Apply the tube of the special tool to the bleed
screws.
When bleeding it is necessary to fill the oil tank in
continuation while working with a MITYVAC pump
on the bleed screws until no more air comes out of
the system.
BRAK SYS - 110
Vespa LX 50