Reprogramming The Command Reverse Unit To Restore Features - Lionel 2-8-4 Berkshire Steam Locomotive and Tender Owner's Manual

TrainMaster Command operations

Reprogramming the Command reverse unit to restore features

D ue to the inevitable derailments and static, it is possible that your Command reverse unit
could someday lose its setup program. The symptom of this condition would be
unresponsiveness in Command mode. This can be easily remedied by "reprogramming" your
Command reverse unit using the following steps.
STEP 1: Move the switch on your locomotive from RUN to PROG.
STEP 2: Plug in your Command Base.
STEP 3: Place the locomotive on track, then turn on power to your track.
STEP 4: Press ENG then input the locomotive's ID#. Press SET.
STEP 5: Press ENG, the ID#, AUX1, then press 74 for this particular locomotive.
STEP 6: Turn off power to your track and wait ten seconds.
STEP 7: Remove the locomotive from your track, and move the switch from PROG to RUN.
STEP 8: Place the locomotive back on track, then turn power on to the track.
STEP 9: Press ENG and the ID#, then operate as normal.
23