Tuning In To A Preset Station - JVC KD-SH707 Instructions Manual

2
Tune in to a station (in this example,
of 88.3 MHz).
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Press ¢
to tune
in to stations of higher
frequencies.
4 to tune
Press
in to stations of lower
frequencies.
"1" flashes for a while.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on page 12.
1
Select the band (FM1 – 3, AM).
BAND
F 1
(FM 1)
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station...
In some areas, adjacent stations may interfere
with each other. If such interference occurs,
this unit can automatically reduce the
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see "To
change the FM tuner selectivity – IF FILTER"
on page 34.
When using this until in an area other than
North or South America:
You need to change the AM/FM channel
intervals. See "To change the AM/FM channel
intervals – AREA" on page 33.
1 Press SOURCE
repeatedly to select
FM or AM as the
source.
2 If necessary, press
BAND (B) repeatedly
to select the FM
band. Each time you
press the button, the
FM band changes as
follows:
F 2 F 3
(FM 2) (FM 3)
13