Tuning In To A Preset Station - JVC KD-S10 Instructions Manual

Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex: Storing an FM station of 92.5 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store FM stations into (in
this example, FM1).
• Each time you press the button, the FM
band changes as follows:
FM
AM
2
Tune in to a station of 92.5 MHz.
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
"P1" flashes for a few seconds.
4
Repeat the above procedure to
store other stations into other
preset numbers.
8
FM1 FM2
FM3
AM
¢ to tune
Press
stations of higher
frequencies.
Press 4
to tune
stations of lower
frequencies.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply
to the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset the
stations again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 7 and 8.
1
Select the band (FM1 – 3, AM).
FM
AM
2
Select the number (1 – 6) for the preset
station you want.
8
7 9
MO
FM1 FM2
FM3
AM
10 12
11
RPT RND