To Change The Altitude Unit; To Manually Reset The Reference Depth To 0 Meters (Feet) - Casio 2782 Operation Manual

3. After waiting four or five seconds, C to move
the flashing to the pressure sensor calibration
setting.
• At this time,
pressure value should be flashing on the
display.
• If OFF
appear at this time, press A to return to the
Barometer/Thermometer Mode screen, and
perform step 2 again.
4. Press D (+) or B (–) to change the displayed barometric pressure by 1
hPa (0.05 inHg).
• Pressing D and B at the same time returns to the factory calibration
( OFF ).
5. Press A to return to the Barometer/Thermometer Mode screen.

To change the altitude unit

1. Press D to enter the Altimeter Mode.
2. Hold down A until
until the display goes blank. This is the setting
screen.
• Wait for four or five seconds before
performing step 3, below. If you don't wait,
there is the chance of setting value error.
• If the display went blank in step 2, the
current reference value will appear
(flashing) on the display after the four or five
seconds pass.
• If OFF or the current reference altitude value does not appear at this
time, press A to return to the Altimeter Mode screen, and perform step
2 again.
3. Press C to move the flashing to the altitude unit setting.
4. Press D to select the unit you want (m or ft).
5. Press A to return to the Altimeter Mode screen.
• The altitude unit you select in the Altimeter Mode is also used in the Depth
Gauge Mode.

To manually reset the reference depth to 0 meters (feet)

In the Depth Gauge Mode, press C and D at
the same time.
• This resets the reference depth and causes the
displayed depth to change to 0 meters (feet).
• Never perform the above operation while
submerged.
Operation Guide 2782
OFF or the barometric
or the pressure value does not
OFF appears (flashing) or
8