Vfo And Memory Scanning - Yaesu FT DX 1200 Operation Manual

VFO
AND
You may scan either the VF or the memories of the FT
a signal strong enough to open the receiver s uelch.
1. Set the VF - to the fre uency on which you would
like to begin scanning.
otate the [ RF/SQL ] knob so that the background
.
noise is just silenced.
ress and hold in the microphone [ UP ] or [ DWN ]
3.
key for one second to start scanning in the speci ed
direction on the VF fre uency.
4. If the scanner halts on an incoming signal, the deci-
mal point between the " H " and "kH " digits of
the fre uency display will blink.
A :
DVICE
If the incoming signal disappears, scanning will
resume in about ve seconds.
n the SSB CW and SSB-based ata modes, the
scanner will pause on a received signal, then will
step across the signal very slowly, giving you
time to stop the scan, if you like. In these modes
on the VF , the scanner does not stop, however.
. To cancel scanning, press the [ PTT ] switch.
A :
DVICE
If you press the microphone PTT switch during
scanning, the scanner will halt at once. However,
pressing the PTT switch during scanning will not
cause transmission.
You may select the manner in which the scanner re-
sumes while it has paused on a signal, using
item "048 MIC SCAN RESUME". The default "TIME"
sec) setting will cause the scanner to resume scan-
ning after ve seconds you may change it, however,
to resume only after the carrier has dropped out.
Page 100
M S
EMORY
VFO S
enu
CANNING
1200, and the radio will halt scanning on any fre uency with
DX
CANNING
FT
DX
[ RF/SQL ] Knob
1200 O M
PERATING ANUAL