Table of Contents
Advertisement
Quick Links
3243 North California Avenue, Chicago, IL 60618
CARAMEL CORN MIXER
MODEL CMD 100
120/208 Volt,
Single Phase, 60 Hz
120/240 Volt,
Single Phase, 60 Hz
230 Volt,
Single Phase, 50 Hz
READ and UNDERSTAND these operating and safety
instructions before operating this popcorn machine
8/99
CMD100-M-C/D/E-O
1
BEGIN SERIAL NO. 99076231
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cretors CMD 100
Summary of Contents for Cretors CMD 100
- Page 1 CMD100-M-C/D/E-O 3243 North California Avenue, Chicago, IL 60618 CARAMEL CORN MIXER MODEL CMD 100 120/208 Volt, Single Phase, 60 Hz 120/240 Volt, Single Phase, 60 Hz 230 Volt, Single Phase, 50 Hz READ and UNDERSTAND these operating and safety instructions before operating this popcorn machine BEGIN SERIAL NO.
- Page 2 CMD100-M-C/D/E-O SAFETY FIRST The information in this manual is essential for the safe installation and of your Cretors popcorn machine. The manual must be read and understood before installing, and operating this equipment, or equivalent training must be provided. "The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury".
- Page 3 CMD100-M-C/D/E-O INTRODUCTION This manual is filled with time-saving and money-saving information regarding your Cretors popcorn machine. There is nothing, however, more important than the safety aids and warnings that are found throughout this document. The Safety Alert Symbol is used to identify topics of primary safety concern wherever they appear.
- Page 4 Non-Stik. This serves to keep the mixer clean and also helps the caramel corn to separate into individual kernels after being coated. 2. Put the contents of 3 bags of Cretors Mix and 6oz. to 18oz of water into the mixer and follow the instructions sent with the mix.
- Page 5 CMD100-M-C/D/E-O 3. Turn on switch marked HEAT. Turn on switch marked MOTOR briefly to distribute mix uniformly over the bottom of the mixer. 4. Set the Temperature Controller on the side of the cabinet to 325°F. It may be necessary to adjust the temperature higher or lower to get the color and flavor you desire.
- Page 6 CMD100-M-C/D/E-O MAINTENANCE THERMOCOUPLE REMOVAL DISCONNECT MACHINE FROM POWER SUPPLY 1. Remove stirrer blade by loosening the mixer bolt-P/N 1681 and then remove stirrer blade cap-P/N 13158. 2. Remove flexible conduit from motor and unplug power leads located under motor wire cover. 3.
- Page 7 Customer Service Department at C. Cretors and Company. Additional copies of this manual can be obtained from C. Cretors and Company at the address listed below. Please provide model and serial number when requesting additional copies of this manual.
Need help?
Do you have a question about the CMD 100 and is the answer not in the manual?
Questions and answers