Connecting The Power Cord; Choosing An Fm Antenna - Bose Acoustic Wave Owner's Manual

Connecting the power cord

Figure 3
Connecting the power
cord at the rear panel

Choosing an FM antenna

Figure 4
The FM antenna
selection switch
Setting Up Your Acoustic Wave
WARNING: Mishandling the remote control battery may cause a fire or
chemical burn. Keep the battery away from children.
Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate
the battery. Dispose of the used battery promptly and responsibly.
Replace only with a lithium CR2032 or DL2032 battery by Duracell,
Eveready, Hitachi, Maxell, or Toshiba (available from most electronics
stores). Other batteries are not UL approved and may cause a fire or
explosion.
For more information, call the customer service number inside the back
cover of this guide.
CAUTION: Bose recommends using a quality surge supressor on all
electronic equipment. Voltage variations and spikes can damage electronic
components in any system. A quality supressor, which can eliminate the
vast majority of failures attributed to surges, may be purchased at elec-
tronic stores.
1. Plug the small end of the power cord into the power jack on the back of
your Acoustic Wave
2. Plug the other end of the power cord into an AC power (mains) outlet.
The system has an FM ANTENNA SELECT switch located on the back of
the unit (Figure 4). The switch should be in the right hand position to select
the telescoping antenna. You may choose to connect an external FM
antenna, if needed, to the EXTERNAL 75 OHM antenna jack. To use an
external FM antenna, slide the switch to the left hand position.
FM ANTENNA SELECT
EXTERNAL
75 OHM
Switch position to select
the external antenna
®
music system (Figure 3).
Switch position to select
the telescoping antenna
®
Music System
7