Selecting A Location For Your Music System; Installing The Remote Control Battery - Bose Acoustic Wave Owner's Manual

Setting Up Your Acoustic Wave

Selecting a location for your music system

Installing the remote control battery

Figure 2A and B
Installing the battery
A
B
6
As with any high-performance sound system, the tonal quality of your
®
Acoustic Wave music system will vary with room placement. Feel free to
experiment, but keep in mind that this system was designed to sound best
when placed on a shelf, counter, desk, or table top, 30 to 48 inches (75 -
120 cm) from the floor. It should be near the center of a wall and 6 inches
(15 cm), or less, away from the wall. To increase bass response, move the
unit toward any corner of the room; to decrease bass response, move it
away from the corner.
Your remote control battery may already be installed. If you need to install
or replace the battery follow the instructions below:
Your remote control may be one of two types (figure 2A or 2B). Each is
identified by the way the battery compartment unlocks.
1. Place the remote control face down on a flat surface.
2. If your remote has a slot on the back (Figure 2A), follow step A. Other-
wise, follow step B and refer to Figure 2B:
A. Insert the tip of a ballpoint pen into the slot. Push to the side as
shown and hold. Slide the battery compartment open with your finger
(and, if necessary, remove the battery).
B. Using your finger, push the tab lock to the side as shown and hold.
Slide the battery compartment open (and, if necessary, remove the
battery).
Slot
Tab
3. Keeping the remote control face down, insert the new battery into the
compartment with the + symbol facing up.
4. Gently slide the battery compartment closed. It locks automatically.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.
®
Music System
+ Symbol
+ Symbol