Rs232 Interface - Code Reader 2.0 User Manual

2.2 - Installation Guide - RS232 Interface
To connect the CR2 to your host computer via RS232 interface:
1. Make sure the RS232 cable is sufficiently attached to
your CR2 unit (figure 2.4).
2. Connect the RS232 interface cable to your host
computer (figure 2.5). If you are unsure of the proper
location to connect the RS232 cable please consult
the manual of your host computer.
3. The RS232 interface should have come with a power supply. Plug the power supply adapter
into the RS232 interface cable (figure 2.6) and then plug the power adapter into a wall socket
(figure 2.7). The RS232 interface does not require additional power. However, if you are using
the RS232 interface and utilizing Batch functionality, please read the Important Note in section
7.1. If you are using the 1400 mAH or 1950 mAH battery for batch mode, the CR2 will recharge
the battery whenever the unit is a attached to a RS232 cable that is plugged into a wall socket.
4. The CR2 will power on automatically.
5. Scan the RS232 One Way Mode code then the Save Settings code to configure reader:
RS232 One Way Mode
Note: All Baud Rate, Parity, Stop Bit and Data Bit settings can be found in Chapter 5.
6. Your CR2 unit should be ready for use. Open the application you wish to send data and begin
scanning.
Figure 2.4
Figure 2.6
Save Settings
Save Settings
Figure 2.5
Figure 2.7
RS232 Factory Default Settings
Mode: RS232 One Way Mode
Max Range
Baud Rate 57600
Stop Bits 1
Data Bits 8
Parity None
C001537_04_CR2 User Manual - 9