Dericam H501W User Manual page 4

Shenzhen Dericam Technology Co.,LTD
 6------
Alarm Output Socket
The alarm output socket is connected with a relay in the IP camera. IP camera will control the switch to trigger
the alarm bell or buzzer to alarm. The relay is able to control the switch of an alarm whose voltage is no more than
36V, and current is lower than 2A. Please refer to the Figure 3.3 for the connection of an external alarm.
 7-----
Alarming Input Pin
Please refer to the schematic Diagram of Figure 3.4 for how external detector collects alarm information.
The detector should be switched type (always on or always off). If the detector has detected the smoke or people or
animal to enter the area, the detector will switch on or switch off. And it will send the external alarm signal into the IP
camera.
 8----
RESET Button
Reset button located in WIFI antenna installation holes below Press the RESET button and hold on more than 10
seconds, the camera will restart and recover to the factory default settings.
Note
Please never press reset button unless you have forget the password to login the camera.
www.dericam.net
Output Pins
Switch
Alarm power
Input
pins
PIR Power
Copyright @ Shenzhen Dericam Technology Co., Limited
Figure 3.3
Figure 3.4
4
H501W User Manual
Alarm
PIR
Switch
tech@dericam.com