Maytag REFRIGERATOR Installation Instructions Manual page 2

240Edwards Street, S E
Cleveland. Tennessee 37311
Tel:423472-3333
Fax: 4 23-478-6710
A READ THIS BEFORE YOU START .................
TOOLS needed for Installation • cutting knife
• slip joint pliers (Dispenser ,'vladels)
• level
• adjustable wrench
(Dispenser Models)
• screwddver-flatblade
(slotted)
• screwddver-crosshead
(phiilips)
• teflon tape
(Dispenser Modets)
UNCRATING
1. Lay the appliance on back.
2. Remove the bottom cap by cutting the band and pulling the cap away.
3. Remove the crate base by removing four (4) bolts.
4. Discard the crate base.
5. Return the appliance to an upright position.
6. Lift the carton up and off. NOTE: If using a hand truck to move the refrigerator, and
the handles were preinstalled at the factory, make sure you NEVER PLACE THE STRAP
OVER THE HANDLES. Avoid overtightening the strap to prevent misaligning the doors.
7. Remove all exterior and interior tape carefully; retain old tape. Make a small pad of this
tape to pick off any remaining tape residues. This will eliminate the need to use dangerous
solvents of any kind.
8. If so equipped, remove and discard cantilever shelf packing clips located just above each
shelf where it hooked onto the frame. To remove a clip. wiggle sideways and pull straight
out.