Water Outlet; Start Of Dishwasher - Baumatic BDW60S Instruction Manual

If the sink is 1000 higher from the floor, the excess water in hoses cannot
be drained directly into the sink. It will be necessary to drain excess
water from hoses into a bowl or suitable container that is held outside and lower
than the sink.
In order to avoid more water staying in the inlet hose,
please close the hydrant after using.(For the models: no safety inlet hose.)

Water Outlet

Connect the water drain hose. The drain hose must be correctly fi tted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip. The free end of
the hose must not be immersed in water.

Start of dishwasher

●
The followings should be checked before starting the dishwasher.
Whether the dishwasher is level and fixed
1
Whether the inlet valve is opened
2
3 Whether there is leakage at the connections of the conducts
Whether the wires are tightly connected
4
Whether the power is switched on
5
Whether the inlet and drain hoses are knotted
6
All packing materials and printings should be taken out from the dishwasher
7
Attention
●
After installation, please put this manual into the bags of printings. The content
of this manual is very helpful to the users.
16