Turning On The Appliance; Change The Programme - Baumatic BDW60S Instruction Manual

NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.

Turning on the Appliance

Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1
push them back. It is commended that loading the lower
basket first, than the upper one (see the section entitled
"Loading the Dishwasher").
2
Pour in the detergent (see the section entitled " Detergent
and Rinse Aid").
3
Insert the plug into the socket. The power supply is 220-240
VAC 50 HZ, the specification of the socket is 12 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
4
When select 8 kinds of wash program
Press the programme button, the wash program will change as follows direction
When a program is selected, the response light will light. Then press the
Start/Reset button, the program is running.
Premise: You can modified the washing program, just
the dishwasher has been running for a short time.
the detergent may have already been released, and the appliance
may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Press start/Reset Button more than three seconds the machine will
be in stand by state ,then you can change the program to
the desired cycle setting (see the section entitled " Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine
will pause. When you close the door and press the start/reset Button,
the machine will keep on working after 10 seconds.
The program lights shows the state of the dishwasher:
a) All program lights off---------------stand by
b) One of the program lights on----------pause
c) One of the program lights blinking----- run
3in1->Intensive->Heavy->Normal->Rinse->Glass->Rapid->Soak;
11
Otherwise,