Cleaning The Spray Arms; Cleaning The Filters - Baumatic BDW60S Instruction Manual

Cleaning the Spray Arms

It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings.
upper
lower

Cleaning the Filters

- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter. you can remove the filter system. Remove any food remnants and clean the
filters under running water.
1
2
3
When following this procedure from step1 to step 3, the filter system will be removed;
NOTE：
when following it from Step 3 to Step 1, the filter system will be installed.
Filter assembly
For best performance and results, the filter assembly must be cleaned regularly. The filter efficiently
removes food particles from the wash water, allowing it to be recirculated during the cycle. For
this reason, it is a good idea to remove the larger food particles trapped in the filter after each
wash cycle by rinsing the semicircular filter and cup under running water. To remove the filter
assembly, pull on the cup handle in the upward direction. The entire filter assembly should be
cleaned once a week.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble the filter
parts as shown in the figures left and reinsert the entire assembly in the dishwasher, positioning
in its seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of the filter may
reduce the performance level of the appliance and damage dishes and utensils.
Never run the dishwasher without the filters in place. When cleaning the filters, don't knock on
them. Otherwise, the filters could be contorted and the performance of dishwasher could be
debased.
Remove the upper spray arms
To remove the upper spray arms, screw off the nut clockwise to take out
the washer on top of the spray arm and remove the arm.
Remove the lower spray arms
To remove the lower spray arm, pull out
Wash the arms
Wash the arms in soapy and warm w ater and use a soft brush to clean
the jets. Replace them after rinsing them thoroughly.
Open
step１：Turn the filter in anti-clockwise direction,
then lift it up
step２：lift the Main filter up
step 3： lift the Fine filter up
13
the spray arm upward .