Table of Contents
Advertisement
Configure the Module
Before you can set up the X330WAN module you must power on and set up the Avaya
P330 stack as described in the Avaya P330 User's Guide.
Before using the X330WAN module you must assign an IP address via the Command
Line Interface (CLI) or via a Telnet session to the switch where the X330 is inserted.
The following steps describe how to configure the X330WAN module using the Avaya CLI.
Establishing a Serial Connection
Perform the following steps to connect a terminal to the Console port of the X330WAN for
configuration of WAN parameters using the CLI:
1.
Use the supplied serial cable to attach the RJ-45 console connector to the Console port.
Connect the DB-9 connector to the serial (COM) port on your PC/terminal.
2.
Use the following serial port settings on the PC: 9600 baud, 8 bits, 1 stop bit and no parity.
If you connected a PC, run a VT-100 emulation session. (You can use the Windows®
HyperTerminal.)
The terminal connected to the serial port must be configured with the same settings; this
setting will work with any PC COM port over a DB9 to RJ45 connector.
3.
Press Enter.
4.
When prompted for a Login Name, enter the default name root.
5. When promoted for a password, enter the password root.
Establishing a Modem Connection
A PPP connection with a modem can be established only after the X330WAN is config-
ured with an IP address and net-mask. Also, the parameters used in the X330WAN
must be compatible with the remote peer parameters.
Commands are shown as follows: ip address; parameters which you need to enter
are shown in <> as follows: <net-mask>
5
All CLI commands mentioned in this section are described in the Avaya P330 Reference
Guide.
To configure a modem interface:
1.
Connect a terminal to the Console port of the X330WAN as described in "Connecting the
Console Port".
2.
When prompted for a Login Name, enter the default name root and press Enter.
3.
When prompted for a password, enter the password root and press Enter. You are now
in Supervisor mode.
4.
At the prompt, type: interface Console and press Enter.
5.
Use the ip address <ip_addr><net-mask> command entering an IP address and net-
mask to be used by the remote peer to connect via its console interface to the X330WAN.
Advertisement
Table of Contents
