JVC GET0576-001A Instruction Manual page 133

Category Menu items
IF BAND
Intermediate
frequency band
*
FADER* 4, 5
Fader
BALANCE *
5
Balance
LOUD
Loudness
VOL ADJUST
Volume adjust
L/O MODE
Line output mode
SUB.W FREQ *
Subwoofer cutoff
frequency
SUB.W LEVEL *
Subwoofer level
BEEP
Key touch tone
AMP GAIN * 7
Amplifier gain
control
*
4 If you are using a two-speaker system, set the fader level to "00."
*
5 This adjustment will not affect the subwoofer output.
* 6 Displayed only when "L/O MODE" is set to "SUB.W."
* The volume level automatically changes to "VOLUME 30" if you change to "LOW POWER" with the volume level
7
set higher than "VOLUME 30."
Selectable settings, [reference page]
• AUTO : Increases the tuner selectivity to reduce interference noises
• WIDE : Subject to interference noises from adjacent stations, but
R06 – F06 : Adjust the front and rear speaker output balance.
L06 – R06 : Adjust the left and right speaker output balance.
• LOUD OFF : Cancels.
• LOUD ON : Boost low and high frequencies to produce a well-balanced
VOL ADJ –05 — : Preset the volume adjustment level of each source (except
VOL ADJ +05
(Initial: VOL
ADJ 00)
• SUB.W : Select if the REAR LINE OUT terminals are used for
• REAR : Select if the REAR LINE OUT terminals are used for
6 • LOW : Frequencies lower than 72 Hz are sent to the subwoofer.
• MID : Frequencies lower than 111 Hz are sent to the subwoofer.
• HIGH : Frequencies lower than 157 Hz are sent to the subwoofer.
6 SUB.W 00 : Adjust the subwoofer output level.
— SUB.W 08
• BEEP OFF : Deactivates the key touch tone.
• BEEP ON : Activates the key touch tone.
• LOW POWER : VOLUME 00 – VOLUME 30 (Select if the maximum power
• HIGH POWER : VOLUME 00 – VOLUME 50
between adjacent stations. (Stereo effect may be lost.)
sound quality will not be degraded and the stereo effect
will remain.
(Initial: 00)
(Initial: 00)
sound at a low volume level.
FM), compared to the FM volume level. The volume level
will automatically increase or decrease when you change
the source.
• Before making an adjustment, select the source you
want to adjust.
• "VOL ADJ FIX" appears on the display if "FM" is selected
as the source.
connecting a subwoofer (through an external amplifier).
connecting the speakers (through an external amplifier).
(Initial: SUB.W 04)
of each speaker is less than 50 W to prevent damaging the
speaker.)
Continued on the next page
15
SETTINGS