Pc5204 Pgm Output Programming; Keypad Lockout Options; First System Options; Second System Options - DSC PowerSeries PC1404 Installation Manual

PC1404

[011] PC5204 PGM Output Programming

Default
01
I_______I_______I
01
I_______I_______I
01
I_______I_______I
01
I_______I_______I

[012] Keypad Lockout Options

Note: If Keypad Lockout is active, the panel CANNOT be disarmed with a keyswitch.
Default
000 Number of Invalid Codes Before Lockout
I_______I_______I______I
000 Lockout Duration (in minutes)
I_______I_______I______I

[013] First System Options

Opt. Def. ON
1  Normally Closed Loops
2  Double End-of-Line Resistors

3  Panel Shows All Troubles While Armed

4 Tampers/Faults Do Not Show as Open

5  Auto-Arm Schedule in [

6  Audible Exit Fault Enabled

7 Zone Doubling Enabled
8  Temporal Three Fire Signal Enabled
Note: When Option 7 is ON, the configuration of Options 1 and 2 should be ignored.

[014] Second System Options

Opt. Def. ON

1 Arm/Disarm Squawk Enabled

2 Bell Squawk During Auto Arm On

3 For Future Use

4 For Future Use
5  For Future Use
6  For Future Use
7  Exit Delay Termination Enabled
8  Fire Bell is Continuous

[015] Third System Options

Opt. Def. ON

1  [F] Key Enabled
2  [P] Key Audible (Bell/Beeps)
3  Quick Exit Enabled

4  Quick Arming Enabled ([,][0] and Function Keys)

5 Code Required for Bypassing

6 Master Code Not Changeable
 
7 TLM Enabled

8 For Future Use

[016] Fourth System Options

Opt. Def. ON
1   AC Trouble Displayed
2  Trouble Light Flashes if AC Fails
3  Blank Keypad When Not Used
4  Code Required to Remove Keypad Blanking
18
PGM 11
PGM 12
PGM 13
PGM 14
][6] + Installer Prog.
*
(Valid entries are 000-255)
(Valid entries are 000-255)
OFF

 End-of-line Resistors

 Single End-of-line Resistors
 Panel Shows Fire Troubles While Armed
 
Tampers/Faults Show As Open
 Auto-Arm Schedule in Installer Prog. Only
 Audible Exit Fault Disabled
 
Zone Doubling Disabled

 Standard Pulsed Fire Signal
OFF
 
Arm/Disarm Squawk Disabled
 
Bell Squawk During Auto Arm Off
 







 Exit Delay Termination Disabled

 Fire Bell Follows Bell Cut-off
OFF
 [F] Key Disabled

 [P] Key Silent

 Quick Exit Disabled
 Quick Arming Disabled (Function Key Requires Code)
 
No Code Required
 
Master Code Changeable

TLM Disabled


OFF
 AC Trouble Not Displayed
  Trouble Light Does Not Flash if AC Fails
  Keypad Always Active
  No Code Required