Safety Instructions - Worx WG151 User Manual

SAFETY INSTRUCTIONS

WArNINg: Some dust created by
power sanding, sawing, grinding,
drilling and other construction activities
contains chemicals known to the state of
California to cause cancer, birth defects
or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and
cement and other masonry products
and
• Arsenic and chromium from
chemically-treated lumber.
your risk from these exposures varies,
depending on how often you do this type
of work. to reduce your exposure to
these chemical:
• Work in a well ventilated area,
• Work with approved safety
equipment, such as those dust
masks that are specially designed to
filter out microscopic particles.
WArNINg: rEAd ANd
6 6
uNdErStANd All INStruCtIoNS.
Failure to follow all instructions listed
below may result in electric shock, fire
and / or serious personal injury.
NotE: Before using battery charger, read
all instructions and cautionary markings
in this manual, on battery charging
stand, battery pack, and product using
battery pack to prevent misuse of the
products and possible injury or damage.
WArNINg: to reduce the risk
of electric shock or damage to
the battery charger and battery pack,
charge only the specifically designated
battery pack that was included with this
charger. Charging other types of battery
packs may cause them to burst, causing
personal injury and damage.
1. do not use the charger outdoors or
expose to wet or damp conditions.
Water entering charging stand will
increase the risk of electric shock.
2. use of an attachment with
Battery charger
this battery charger that is not
recommended may result in a risk
of fire, electric shock, or injury to
persons.
3. do not abuse the cord on the battery
charger. Never carry the charger by
its power cord. Never pull the power
cord to remove the transformer from
the power outlet. Damage to the cord or
charger could occur and create an electric
shock hazard. Keep cord away from heat,
oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged
cords increase the risk of electric shock.
4. Make sure cord is located so that it
will not be stepped on, tripped over,
come in contact with sharp edges or
moving parts, heat, oil, or otherwise
subjected to damage or stress. This
will reduce the risk of accidental falls,
which could cause injury, and damage
to the cord which could result in electric
shock.
5. keep cord and battery charger away
from heat to prevent damage to
housing or internal parts.
6. do not let gasoline, oils, petroleum-
based products, etc. come in contact
with plastic parts. They contain
chemicals which can damage, weaken or
destroy plastic.
7. An extension cord should not be
used unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock.
If an extension cord must be used, make
sure:
a) That pins on plug of extension cord are
the same number, size and shape as
those of transformer on charger,
b) That extension cord is properly wired and
in good electrical condition, and
c) That you use a proper extension cord.
oNly use cords listed by Underwriters
Laboratories (UL) and/or Canadian
Standard Association (CSA). Other
extension cords can cause a drop in
line voltage, resulting in a loss of power
and overheating of charger. An AWG
(American Wire Gauge) size of at least 14-
EN