Planet Networking & Communication ICA-1200 User Manual page 54

Full HD PoE/ Wireless Cube IP Camera
ICA-1200/W1200
This value is dependent to "Auto Exposure" only
Color Level Large value will be colorful.
Hue Change the value will result to color tuning.
Brightness Large value will brighten camera.
Sharpness Large value will sharpen camera.
Contrast Large value will contrast camera heavily.
Enable or disable video signal of BNC to a TV monitor. It's very
useful to check view angle or focus during camera installation.
Local video output
However, disable this function will save power a lot. Suggest to
disable it after camera installed
Use built-in photo sensor or manual to control ICR.
In case user selects manual mode, there are 4 modes: Night
(On), Day (Off), Auto or Schedule to control built-in IR LEDs. This
function is very useful under low illumination environment even 0
Lux.
In case the Auto mode is selected, user needs to specify 3
parameters in advance:
Night Mode Threshold (0~10000): this value set the threshold to
ICR turn on IR LED. It should be lower or equal to Day Mode
Threshold.
Day Mode Threshold (0~10000): this value set the threshold to
turn off IR LED. It should be higher or equal to Night Mode
Threshold.
Delay Time: The delay time between LED ON/OFF switching.
Note: that Current Value is the current luminance from the
captured video. It's a useful reference to set LED ON/OFF
Threshold.
3D De-Noise can remove or lower unwanted noise and preserve
3D De-Noise
fine details and edges.
This function is to provide clear images even under back light
WDR circumstances. The higher "Strength" level will adjust contrast
compensation stronger.
Default Settings Restore to factory image settings.
54