Advertisement
3. Rotate the router until the three mounting holes in
the router base line up with three of the holes in
the table top. (It will be helpful if you orient the router
such that you can easily reach the ON/OFF switch
from the front of the table. Sears Craftsman
25182 Router Table Switch Package provides
easy access to ON/OFF button).
4. Insert three #10-32 x 3/8" long flat head machine
screws (provided) throUgh holes in the table top
(See Fig. #3) and tighten securely into the router
base.
SELECTING AND INSTALLING
TABLE INSERTS
With the desired bit in the router, select a table insert
which has a center hole slightly larger than the diameter
of the router bit. Note: For bits larger than approximately
1 3/8" diameter, do not use an insert.
The table inserts were designed to be snapped into the
router table. Slide the large tang under the edge of the
large hole in the router table as shown in Fig. #4. Using
your thumb, press down on the insert until the small tang
snaps into position.
Use Thumbs Pressure to
Snap TaIeinsert
Into Position
To remove the insert, place the point of a small screw-
driver into the slot (with the small tang) and pry the insert
out of the router table.
WARNING: BEFORE ASSEMBLING AND ATTACH-
ING UNITIZED FENCE TO TABLE,
MAKE SURE THAT ROUTER IS
UNPLUGGED AND THE BIT IS BELOW
THE TOP SURFACE OF THE TABLE.
ASSEMBLY OF UNITIZED FENCE
ASSEMBLY OF JOINTING FENCE TO UNITIZED
FENCE
1. Slide jointing fence through rectangular opening
in the cavity provided on the unitized fence (ribs
on the unitized fence will slide in the grooves on
the underside of jointing fence). See Fig. #5.
Fig. #5
2. Insert 1/4-20 x 1" long flex head bolt through the
hole in the unitized fence (fron the underside) and
the slot in the jointing fence.
3. While holding the head of the bolt in the hex recess
on the underside of unitized fence, place a flat
washer over the bolt and screw small 1/4-20 knob
on bolt.
When knob is loosened, the jointing fence can slide back
and forth in the cavity for proper jointing adjustment.
ASSEMBLY OF RETRACTABLE GUARD TO UNI-
TIED FENCE
1. Place the unitized fence upside down on a flat sur-
face as shown in Fig. #6.
Hex Recess
Use Screwdriver to
Remove Table Insert
9/32"I.D.x3/4" O.D.
- 1/4-20 Knob (small)
rii vvasnr
Unitized Fenc
.iLA
-
-
,--
',.
Advertisement
