Adjustment When Replacing A Part; Uploading/Downloading Eeprom Data - Oki OKIPAGE 14i Maintenance Manual

4.2

Adjustment When Replacing a Part

Adjustment is necessary when replacing any of the following parts.
4.2.1

Uploading/Downloading EEPROM data

When the controller printed circuit board is replaced, the contents of the old EEPROM shall be copied
to the new EEPROM on the new board to preserve customer settings. For the purpose, use the EEPROM
operation on the Option of the Maintenance Utility. To copy follow the steps below.
(1) Be sure to confirm that the printer and the PC are connected with a centronics I/F cable. Then
execute the Maintenance Utility.
Note: Printer driver shall be deinstalled.
(2) Select the Option on the Maintenance Utility.
(3) Click the "UPLOAD EEPROM" button on the "EEPROM Operations".
(4) The contents of the EEPROM data is displayed on the "DIALOG" of the Maintenance Utility. The
contents of the old EEPROM is now copied into the memory of the PC.
(5) Replace the controller P.C.B. with a new one while it displays the above "DIALOG".
(6) After the replacement, click "Downloaded EEPROM" on the "EEPROM Operations". EEPROM
upload has been completed.
In case of troubles such as centronics I/F failure, etc. EEPROM data may not be uploaded properly. In
such case, it is necessary to adjust the following settings manually after the replacement using the
Maintenance Utility.
• Factory setting (ODA/OEL/INT-A/INT-L)
The maintenance utility is designed to be used only by field engineer and it should not be released
to the end-users.
41356801TH Rev.1
Part Replaced
Image Drum Cartridge
Main Control Board
Adjustment
Reset the image drum counter
(refer to User's manual).
EEPROM data Upload / Download
76 /