Thank you for purchasing the HZ-CA13U Cine lens adapter.
HZ-CA13U is an adapter for mounting 16mm cine lens to JVC ProHD Camcorder.
Compatible camcorder : HZ-CA13U can be used on Camcorder which lens mounting method is 1/3-inch Bayonet type.
GY-HD100U/E, GY-HD101E, GY-HD110U/E, GY-HD111E, GY-HD200U/E, GY-HD201E
Mounting Cine lens
Attaching the Cine Lens Adapter to the Camcorder
Loosen the mount ring of the camcorder.
Attach the cine lens adapter with its pin aligned with the
hole in the mount.
Tighten the mount ring of the camcorder.
In the case of fixed-focus lens, adjust the lens focus to t
take picture of object (30m far away or above) and then
adjust using Back focus adjust ring such that the back focus
is adjusted properly.
: x 0.47
: f / 1.4
: 138.2 mm (Mount to Mount)
: φ78 mm
: 860 g
Mount for lens side
: PL Mount
Mount for Camera side : 1/3-inch Bayonet Mount
© 2007 Victor Company of Japan, Limited
Cine Lens Adapter
1/4-inch UNC20 Screw hole
Back focus adjust ring
Back Focus Adjust Ring
When zoom lens is mounted, use Back focus adjust ring to
adjust if the back focus is out of adjustment. Firstly, set to
Telephoto position and adjust the lens focus, then set to
Wide-angle position and adjust using Back focus adjust ring
such that the focus is adjusted properly.
• Be sure to tighten the mount ring completely. Incomplete
tightening may result in the lens dropping off or disturbed
• Set the Camcorder's power switch to "OFF" before the zoom
lens is attached or detached.
• This adapter is exclusively for 16mm Cine lens.
• 1/4-inch UNC screw holes for lens support are provided on
this adapter. Attach the lens support always when using the
• When taking picture using this adapter, the image will be
displayed upside-down on the monitor. A menu to restore
the upside-down image is available on GY-HD200/201/250/
Dimensions (unit: mm)
F.B 52in air
1/3-inch Bayonet Mount
138.2 (Mount to Mount)
F.B 31in air