For digital video camera gr-dvp1, gr-dvp3 (11 pages)
Summary of Contents for JVC WB-1540U
Page 1
OUTDOOR HOUSING WB-1540U WB-1550U For Customer Use: Enter below the Serial No. which is located on the body. Retain this information for future reference. Model No. WB-1540U/WB-1550U Serial No. INSTRUCTIONS WB-1550U only LST0267-001C...
These are general IMPORTANT SAFEGUARDS and certain items may not apply to all appliances. IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. All warnings on the product and in the operating instructions should be adhered to. 4.
Page 3
● Consult the dealer or an experienced radio/TV technician for help. CAUTION CHANGES OR MODIFICATIONS NOT APPROVED BY JVC COULD VOID USER'S AUTHORITY TO OPERATE THE EQUIPMENT. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
Getting Started Thank you for purchasing this product. (These instructions are for WB-1540U/ WB-1550U) Before beginning to operate this unit, please read the instruction manual careully in order to make sure that the best possible performance is obtained. The compatible cameras for each housing are as follows: ●...
T2: Power will not be supplied to this unit and the installed camera when the fuse on the main board burns out. When this occurs, please consult your nearby JVC dealer as exchange of fuse according to the rating (125 V - 5 A) will be required.
Before mounting. Notch Remove the ceiling mount cover of the camera and guide the cables supplied with WB-1540U through the cover. T For further details, please refer to the instruction manual of the camera in use. Connect the AC 24 V output cable to the camera Connect the AC 24 V output cable of the main board to the camera’s ceiling mount bracket.
Mounting Before mounting. Remove the ceiling mount cover of the camera and guide the cables supplied with WB-1540U through the cover. T For further details, please refer to the instruction manual of the camera in use. Connect the AC 24 V output cable to the converter unit.
Installation and Connection (WB-1540U) Assembling the Housing Safety Wire Desiccant Screw B (M4) x 6 Mounting the Housing to the wall Anchor Bolt (M8, 35 mm and above) Washer Safety Wire 1. 2. Installation Position Adhering the desiccant Use a tape to adhere the supplied desiccant to the interior of the lower housing.
Page 9
Mounting the Housing to the Wall (continued) Waterproofing Screw (M3 x 12) x 4 Alarm/Communication Cable LAN Cable (Male) Coaxial Video Cable AC 24 V DC 12 V Power Cable Power Cable Hole Waterproofing Bind with insulating tape Bind using a waterproof (adhesive) tape Not in use on this system.
Installation and Connection (WB-1550U) Disassembling the Housing Safety Wire Screw B (M4) x 8 Procedures Before Mounting the Camera Rubber Gasket (White) Camera Body Cover Main Unit Dome Cover Rubber Gasket Dismantle the gasket and gasket gland Loosen the 8 Screws B (M4) using a driver, followed by dismantling the gasket and gasket gland from the lower housing.
Mounting the Camera (TK-C655E and TK-C676E) Interior of Housing JVC Mark Camera Mounting Bracket Safety Wire Main Board AC 24 V Output Cable To [POWER INPUT AC 24 V] Terminal of Ceiling Mount Connect the AC 24 V output cable to the camera Connect the AC 24 V output cable to the ceiling mount of the camera to be installed.
Connect other cables Notch Connect the necessary cables supplied with the housing JVC Mark (coaxial video cable, alarm signal cable, LAN cable, etc.) to the corresponding terminals on the ceiling mount. CAUTION: ● Connect the communication cable to the alarm terminal if necessary.
Assembling the Housing Safety Wire Desiccant Screw B (M4) x 8 Mounting the Housing to the wall Anchor Bolt (M8, 35 mm and above) Washer Safety Wire 1. 2. Installation Position Mount the desiccant Use a tape to adhere the supplied desiccant to the interior of the lower housing.
Page 14
Installation and Connection (WB-1550U) Mounting the Housing to the Wall (continued) Waterproofing Screw (M3 x 12) x 4 Alarm/Communication Cable LAN Cable (Male) Coaxial Video Cable DC 12 V Power Cable AC 24 V Power Cable Hole Waterproofing Not in use on this system. Open the cable connection cover Use provided hexagon wrench to remove the 4 screws (M3 x 12) from the cable connection cover to open it.
Others Specifications WB-1540U General Power / Voltage : AC 24 V 50 Hz/60 Hz (Main Housing Unit) Power Consumption : 25 W (During heater operation, excluding camera) Installation Location : Outdoor (general) Ambient Temperature : -20 I to 50 I (when equipped with...